Original Shredder kit V3.3

If you're looking for your first shredder kit to start shredding, then you are in the right place.

After manufacturing over 250 shredder kits version 2.1 I decided to continue my adventure with version 3.3 because it offers more :)

V3.3 design is much stronger than previous version V2.1 of the PP shredders, much easier to assemble and service during maintame. The V3.3 has never been so simple and accessible.

What's Included?

1) Laser cut parts in 99% cleaned and ready to assemble (but could happen if you will need to
adjust them with file to the right size)

2) 30mm Machined Hex Shaft with 8mm keyway already grooved for coupling fitment.

3) Pre Welded Mesh and Mesh Support (8mm holes) with new bolt system for easier mount

4) All Nuts & Bolts. M10 Threaded Rods.

5) High-Quality UCFL206 bearings (stronger than in version 2.1)

Everything you need to build this shredder is included. Very basic engineering skills are needed.

This V3.3 is designed towards a modular format, disassembly and assembly for maintenance purposes is very fast and easy. Just like LEGO bricks.

Motor and Worm Gearbox are not included. However I recommend a single phase 3kw 2800rpm electric motor with a worm gear ratio 40:1 (56rpm and 300 Nm torque) or 50:1 (70rpm and 380 Nm torque). This is the configuration I tested and it works for me. I know that other engineers are also using the configuration of a single phase 1440rpm electric motor with similar worm gear ratio.

What's Changed Since v2?

1) Upgraded shaft from 20mm to 30mm for extra shredding strength.(Old shaft  in V2 could broke because of not enough structural strength when shredding thicker plastics)

2) Thicker Steel Plates for greater structural strength (in V2.1-  3mm, 5 and  6mm plates. Now it's 10mm and 5mm)
3) The Sieve frame & mesh are already pre-welded and are made from stainless steel. (Everything bolts together so no welding skills required)

4) The sieve has been fully re-designed for safety plus to allow ease of handling and fitment into the granulation area.(Old sieve sometimes could get stuck)

5) A handle is added to the sieve frame underside for easier use.

6) As an option I can offer handcrank module - you will be able to add lever as long as you will be needed. That module is made from 15mm thick steel.

The price does not include customs clearance if applicable.

Contact me for shipping rates to destinations which are not listed.

Best regards

Aero Design Precious Plastic Studio